DIY Self-Assembly Rope Tensioner for 4mm Wire Rope with Grub Screw M6 for External Thread / Right

Installation:
The wire rope is fully inserted into the hole and secured by tightening the three grub screws. This secures the rope in the tensioner. The cable can be shortened to the required length on site, eliminating the need for time-consuming crimping. The terminal has an M6 internal thread on the opposite side into which the fastening screw is screwed. Tightening the fastening screw simultaneously tensions the rope.
However, it should be noted that the terminals are not suitable for suspended or load-bearing loads

.DIY self-assembly - Terminal

article	Wire rope Ø	Thread - G	Ø 1	Ø 2	X	L1	L2
DIY4i	4	M6 - RH	4,4	12	3x M6	60	16

External thread M6

article	Wire Ø	Thread - G	L 1	L 2	L
bLR6	-	M6 - RH / LH	30	30	66